The thickness of the shaft walls is 80 mm, a height of 2780 mm with dimensions in plan 2200 x 1760 mm. To fasten the elevator equipment in the reinforced concrete walls of the mines, steel, in the form of plates, embedded parts are provided.
The lifting of elevator mines is carried out by the four -sewed string for the scum (loops) with a tower crane during the installation of the building. After the reconciliation and installation of the element of the mine on the cement mortar in the doorway, an inventory light metal fence is immediately installed. Part of the elevator mines during the construction of the building serves for vertical transport of small cargoes using permanent elevators of elevators. During this temporary operation, the elevator cabin is protected by inventory shields from damage.
Volumetric separate two -layer plumbing cabins of full factory readiness are made of large -sized asbestos -cement sheets without a metal frame. Cabin walls consist of two flat asbestos -cement sheets 10 mm thick. Antiseptic wooden rails with a section of 10 x 20 mm are laid between them. Sheets are connected to the panel on aluminum rivets. The ceiling is made of single asbestos -cement sheet.
The ceiling panel is also attached to the wall panels with aluminum rivets with a laying of a special plastic stack in the seams. On rivets is connected to wall panels and floor panel. A cement baseboard is laid along the perimeter of the floor. To rise the cabin to the bottom, the embedded parts of the corner 65 x 63 x 5 mm are attached to the bottom, to which the loops of reinforcement with a diameter of 10 mm are welded. In the places of passage of pipes, polystyrene bushes are laid.
Cabins are equipped with baths, toilets, washbasins and towels. In the manufacture, they are tied with the necessary tap and sewer pipelines, hidden electrical wiring is laid in the sinuses. Walls and ceiling are painted with synthetic paint Neva. The floors are made of Metlah tiles on mastic.