During the construction of a log bath, the main material is round logs or a calibrated timber. The logs are laid in rows, making on the bottom of each log of the grooves that create the stiffness of the design of the bathhouse. Cut through the grooves, the log is laid on the rounded surface of the previous log. At the time of laying the logs between them, a pacley layer is placed either a hemp point, or a moss with a width of more than one centimeter.
Before you start building from logs under the lower log, the so -called crown, put a roles in two layers. This is a waterproofing of a tree from a concrete foundation, because concrete absorbs moisture and so that it is not transmitted to wood pave the roofing material. The bath can be made not only from logs, but you can also use a wooden beam. To fasten the beam, the so -called dashes 10 cm long and 25 mm with a diameter of 25 mm are used between themselves, more than 2 spikes should be placed on each beam. All compounds with the inner walls, also all angles are collected in a spoon or in a paw.
The largest wall length in a bar from a beam should not exceed 6.5 m., If the wall length exceeds, then to avoid the likely bulging of the wall, you need to put it vertically compressed. As in a bathhouse from logs, pacli or moss are laid between the bars. And when you finished building the walls of the bath, all the grooves between logs or a beam must be drunk using the pacli. After your brown or log bath is a year and a half (specifically there will be so much time to all logs, or the beam completely gives a shrinkage), it is necessary to pump all the compounds and the newly formed cracks of the bag again.