So that the hot summer does not take by surprise, buy air conditioning from the company whose site is presented by link
Wall preparation should begin with dismantling. The surface of the walls should be cleaned of old wallpaper. If the old plaster is poured and departs, it must be repelled. The peeled walls must be thoroughly primed. The next stage of work depends on the surface of the walls.
Brick walls without plaster. In this case, the walls need to be plastered along the lighthouse with a cement mortar or dry mixtures for plastering. This is a rather difficult job and it is better to entrust it to professionals.
The walls are plastered. If the walls are already plastered, it is necessary to determine the degree of unevenness. If the walls are even, they should be fanned with putty on a plaster, in 2 thin layers. Thus, all defects will close – holes, dimples, cracks. If the plaster is uneven, the walls must be leveled using the rule with aligning putty. Do not forget that the walls must first be disconnected and let it dry. Typically, the duration of the primer is 2 hours. When the walls are linked, you need to let them dry and then light it with sandpaper. Then, primed the finished surface of the walls, let the embarrass and you can glue the wallpaper.
On the walls from the slabs, the process of preparing walls is the same as on the brick walls.
Gypsum plasterboard walls. Here it is necessary to glue the seams with a sickle – a special reinforcing mesh and sparkle with putty on a gypsum basis. Self -tapping hats also put a sparkle. Next, roll and primed. Give the primer to dry and you can glue the wallpaper.