One of the important points is the installation of windows for a frame house. The size of the window opening should be eighteen percent of the entire area of the wall. If the frames are embedded in the house, which is intended for living all year round, then the frames should be with double glass packet or triple. This will mainly depend on the area of residence. After the walls of the OSB sheets and the openings under the windows are covered with waterproofing and windproof films.
This is done very simple: the opening of the windows closes. And I also think that each person used the essential oil from time to time. It is enough to cut the orange peel, and the air will be filled with a familiar warm aroma. After installing new windows, use an orange essential oil in order for the smell of wood and smoke from a drill or other tools.
Further, the film is cut very carefully, and the ends are bent inside this opening, and then fixed around the perimeter, while a stapler is used for construction.
A block is inserted into the window opening, they give it a horizontal and upright position in level. Boards, cut, are placed under the binding of the windows, and then with the use of self -tapping screws, the window block is fixed in the opening. The installation foam is applied along the perimeter, which ensures the seam tightness.
The mounting type of foam is used for work outside, and then the window block is discouraged. During this period, you need to keep the window closed so that there is no “bursting” of the window binding and after all the completion of all work it simply cannot be closed.
If there is no protective transport film in the window block, then along the perimeter of the side on the outside it needs to be covered with tape for painting work, so that when expanding foam, it could not get to the binding. After all, to remove the foam dried up, it can be very bad in appearance.
After drying the mounting foam, you need to carefully remove its excess so as not to damage the film.
The seam from the inside, which is located between the wall and the window block, glue with the tape. It is necessary to ensure that the tape ends are blocked by each other. First you need to glue the strip at the bottom of the window, then the stripes vertically and then the upper strip, which closes the vertical stripes, additionally, this tape is shot with a stapler.
This type of structure does not allow moisture to get on the opening of the windows and its binding.